Mechanical door lock with a key
The mechanic lock is placed on the upper front surface of the door close to the closing mechanism. It serves for avoidance of the device opening by a non-authorized person.
Flexible PT 100
Another additional freely movable sensor inside of the chamber; it can be used for measuring temperature inside the chamber or in the material. The sensor conductors are taken out to the connector placed in the rear part of the device. The display shows the data on temperature of the sensor.
Access port ∅ 25, 50, 100 mm
The ports are designed for pulling the conductors for measuring of temperature, humidity, etc. Possibility of selection of diameter, number and placement of ports. The ports are made of metal, closed with a special plastic cover from the outside - the cover allows pulling of conductors, etc. from the outside to the chamber space.
Window and inner light
In all the volumes, except for the volume of 22 litres and IC and ICV incubator type. It serves for control of operation inside the chamber without necessity of the device door opening. Up to 250°C only.
Ventilation prolongation flange
Possibility of chimney prolongation in 5 cm (suction and exhaust hole), for connection to the external ventilation system, with the possibility of condensation groove for condensate outlet and also with a bend in 90°.
Software WarmComm 4.0
It is designed for recording the temperature regulation progress in heating cabinets. Data obtained in the course of regulation is displayed in the form of a graph (with the horizontal axis showing the time and the vertical axis showing the data obtained). The program allows monitoring of regulation in real time, saving the regulation progress to a disc and also viewing of formerly created files.
Multi-point measuring of an empty chamber according to DIN 12 880, supply of attests for components together with non-filled-in IQ and OQ documentation and possibly also validation measuring with a batch.
IQ/OQ documents including measurement
„Installation qualification (IQ) - It proves and documents that the device and its supporting systems are appropriately selected, correctly installed and that they comply with required specifications.
Operation qualification (OQ) - It proves and documents that the device may repeatedly and reliably perform the proposed functions within the range of operation parameters.
It allows archivation of the process running in the chamber of the device. A heading is printed on the print tape, containing information on device type, pre-set temperature, respectively ramp, number of cycles, fan revolutions and selected time interval of printing. values of the following data are printed in one line below the heading: time from program start, real temperature in the chamber.